Currently I have finished the block out for my micro blacksmith scene. I decided to mostly use the models that my instructor has provided with a few models that I found on Turbo Squid. If I ever do finish my scene earlier than expected then I plan to add in a few more model to my scene.
The four models that I have found on Turbo Squid are the table, pot, shield, and the sword. The furnace, barrel, anvil, stool, and the hammer are taken from the instructor and the sword stand is something that I decided to model myself.
I have finished setting up the UV's for the hammer and the stool. I have also finished setting up the UV's for the shield and the sword but when I went back to check on them the next day the UV for the shield was gone and the UV for the sword was scrambled all over the place. It is a minor set back but thankfully it is easy to UV the sword and shield again.
This is the UV map for the hammer which was pretty simple to accomplish. I separated the handle of the hammer from the base UV wise to make it easier to texture into Substance Painter.
This is the UV map for the stool that has been finished but may be in need of some tweaking to get some good detail on my textures.
I plan on UVing the rest of my models and I plan to move on to my texture phase next week. Overall I had a easy time UVing these models but I do expect to run into problems once I run into more complex models that needs to be UV'ed in a certain way.
No comments:
Post a Comment